Tech & Build Guides
Workshop-floor knowledge for NZ builders.

Turbo Oil Feed & Drain Plumbing: Restrictors, Line Sizes, and the Gravity Rule
Feed a turbo with a small restricted line (-3/-4), drain it with a big one (-10 minimum) that gravity-falls into...

Fuel Filters for EFI: Micron Ratings, Pre- vs Post-Pump, and When to Run Two
Coarse filter before the pump, fine filter after it. Why EFI runs two filters, what micron ratings mean, and how...

Fuel Pressure Regulators: Return vs Returnless, and How to Set Base Pressure
A bypass (return) regulator vents excess fuel back to the tank and holds rock-steady pressure under boost. The NZ guide...

How to Assemble a PTFE AN Hose: Workshop-Floor Walkthrough
Build a PTFE braided AN hose end the right way once. Tools, the six-step assembly, the tightening rule, and the...

E85 Conversion: The Complete Fuel System Upgrade Checklist
E85 needs ~30% more fuel volume and dissolves nitrile, brass and some plastics. The complete component-by-component checklist to convert a...

Surge Tank vs Swirl Pot: When You Need One and Which to Pick
A surge tank holds a primed fuel buffer so your pumps never starve under cornering or braking. When you need...

Catch Can Setup Guide: PCV Routing for Boosted Engines
On boost the PCV pushes oil mist into your intake. The NZ guide to plumbing a catch can: NA vs...

NPT, BSP, ORB, AN: The Thread Identification Cheat Sheet
NPT tapers and seals on the thread. BSP seals on a washer. ORB uses an O-ring. AN is a 37°...

Oil Cooler Sizing: How to Stop Your Engine Cooking on Track Days
Size an oil cooler by displacement and use case: 10-row street, 19-row track, 25-row-plus endurance. Mounting, thermostats, line sizing, and...

PTFE vs Rubber Fuel Hose: Which Line Do You Actually Need?
PTFE is chemically inert, so it is required for E85, methanol and brake fluid. Rubber-lined suits petrol, oil and water....

How to Choose the Right Fuel Pump for Your Power Target
Size a fuel pump by litres-per-hour, not box horsepower. BSFC rules of thumb, an LPH-by-HP chart, in-tank vs external vs...

AN Fitting Sizes Explained: The NZ Builder's Thread Chart
AN sizes match hose inside diameter, not OD. -6 = 3/8", -8 = 1/2", -10 = 5/8". The NZ builder's...







