Tech & Build Guides
Workshop-floor knowledge for NZ builders.

Planning an AN Plumbing Job: Hose, Fittings and Tools
A practical, in-order checklist for planning a braided, PTFE or push-lock plumbing job from scratch.
Read article →
Banjo Fittings and Bolts: Brake, Fuel and Turbo Oil Feeds
What banjo fittings do, where they suit, and how the bolt and sealing washers make a leak-free join.

Bulkhead Fittings: Running AN Lines Through a Firewall or Tank
How AN bulkhead fittings pass a line cleanly through a firewall, fuel cell or panel, and what you need to...
Silicone Hose Shapes Explained: Elbows, Reducers, Humps and More
What each Aeroflow silicone shape does and where it goes in a boost, coolant or vacuum system.

AN Hose End Series Explained: Which Aeroflow Ends Suit Your Hose
The series number tells you how a hose end seals and which hose it suits. Here's the full breakdown in...

Fuel Rails: Flow-Matching the Rail, Pump, and Lines to Your Injectors
A fuel rail is a pressurised buffer that feeds every injector evenly. How rail volume, feed-line size and the regulator...

Hard-Line 101: Aluminium vs Stainless, Tube Nuts, Sleeves, and Flares
Aluminium hard-line bends and flares easily; stainless is stronger but harder to work. How tube nuts and sleeves seal a...

Catch Can vs Air-Oil Separator: What's the Difference, and How to Plumb a Dual-Port
A catch can collects oil mist; an air-oil separator returns clean air to the intake and drains the oil. When...
Silicone vs Rubber Coolant Hose: Temp Ratings, Shapes, and Clamp Choice
Silicone handles more heat and lasts longer than rubber for coolant, but it is not fuel or oil rated. Shapes,...

Wideband O2 & AFR Targets for E85: What the Numbers Mean
E85 runs a different stoichiometric ratio to petrol, so tune in lambda, not petrol AFR. Sensor choice, bung placement, and...

Weld-On Bungs & Fittings: O2 Sensors, AN Bungs, and Matching the Metal
O2 bungs are M18 x 1.5 and go on the exhaust before the turbo's heat soaks them; AN weld bungs...

Swivel vs Fixed AN Hose Ends: When the Extra Cost Pays Off
Full-flow swivel ends clock to any angle and reassemble; one-piece ends are cheaper but fixed. When each is the right...







