Two hose ends can carry the same fuel at the same pressure. The difference shows up when you're trying to clock a fitting in a packed engine bay at 11pm.
The difference
A full-flow swivel end has a rotating socket, so you can spin the hose to any angle before tightening, then unbuild it later and reuse it on a new length. A one-piece end is set: the angle is fixed when it's made, and it stays with that hose.
| Swivel (full-flow) | One-piece | |
|---|---|---|
| Clocking | Any angle | Fixed |
| Reusable | Yes | No |
| Cost | Higher | Lower |
| Best for | Tight routing, rebuilds | Simple fixed runs |
→ See all hose and hose-end options
Matching the series to the hose
Hose ends are not interchangeable between hose types. Match the end to the hose family printed on its product page. Aeroflow 200 Series and 570 Series PTFE ends both suit 200 Series (stainless braid) and 250 Series (nylon braid) hose. Confirm the hose family first, then choose swivel or fixed within it. See our AN sizing chart if you're unsure what size you're running.
What we stock for this
570 Series PTFE 90° Hose End -3AN
Full-flow PTFE end. Clocks to any angle, rebuildable. For E85, brake and methanol lines.
200 Series PTFE Straight Hose End -6AN
-6AN straight end. Suits 200 (stainless braid) and 250 (nylon braid) Series hose.
200 Series PTFE Straight Hose End -8AN
-8AN straight end. Suits 200 (stainless braid) and 250 (nylon braid) Series hose.
Swivel for tight bays and rebuilds. One-piece for simple runs. Always match the end to the hose family on its product page.
Shop Hose & Hose Ends → Genuine Aeroflow stock. Ships overnight from Palmerston North.










